Subsequently, for comparison of JKD6159

and other ST93 strains (Table  1), detection of chemiluminescence was performed using the MF-ChemiBIS 3.2 platform (DNR Bioimaging systems). Quantitation was performed using Image J [32]. Detection of PSMα3 expression HPLC chromatography was performed on an Agilent Technology Volasertib molecular weight 1200 Series system with an analytical Agilent Eclipse XDB-C18 (4.6 mm × 150 mm) column. A water/acetonitrile gradient (0.1% trifluoroacetic acid) from 0 – 100% acetonitrile over 28 min at a flow rate of 1 mL/min was used. The total run time was 32 min, and peaks were quantified at a wavelength of 214 nm. The deformylated and formylated form of PSMα3 MEFVAKLFKFFKDLLGKFLGNN was identified in the S. aureus TSB culture supernatants by comparison of their retention times to a commercially synthesized PSMα3 standard (GenScript) and by spiking the samples with the synthesized standards. The identity of the deformylated peptide present in the samples was confirmed by analysing collected fractions by ESI-MS. There was only one peptide present in this fraction; the deformylated form of PSMα3. In contrast, other peptides were observed in the fractions of USA300, JKD6272, TPS3104, TPS3105r, and JKD6159_AraCr containing the N-formylated form of PSMα3. In these cases, the percentage of N-formylated PSMα3 peptide was determined using the total ion count of the major

peaks in the ESI-MS and the peak area of the HPLC chromatogram was adjusted accordingly. The concentrations GSK621 chemical structure of the deformylated and formylated forms of PSMα3 were determined by comparison of their peak areas to those of the synthesized standards. The standard curves were constructed in the

concentration range of 6.2 – 100 μg/ mL and were linear over this range. DNA methods, molecular Selleck Depsipeptide techniques and construction of mutants DNA was extracted using the GenElute kit according to the manufacturer’s instructions (Sigma-Aldrich). A lukSF-PV knockout, hla knockout and a repaired agrA of TPS3105 were generated according to the published method [34]. For the knockouts, BAY 11-7082 supplier flanking sequences were amplified and ligated prior to cloning with pKOR1. For allelic replacement to generate TPS3105r, a PCR product of agrA from JKD6159 was cloned with pKOR1. For allelic replacement JKD6159_AraCr, a PCR product of this AraC regulator from TPS3106 was cloned with pKOR1. The deletion of the whole psmα locus in JKD6159, chromosomal restoration of psmα in JKD6159∆psmα and the restoration of Hla expression in JKD6159∆hla were conducted using the pIMAY protocol described by Monk et al. [35]. Knockout and restoration amplimers were cloned into pIMAY by SLIC [36]. The primers used are listed in Additional file 11. The knockout and restoration clones were confirmed by PCR and Sanger sequencing of the mutated locus.