It is found that the Pt nanodots corresponding to 70 deposition c

It is found that the Pt nanodots corresponding to 70 deposition cycles exhibit a density as high as approximately 2 × 1012 cm-2 and a well-separated distribution, and most of them appear in the form

of a sphere. In addition, an electron diffraction image of the selected area shows that the Pt nanodots are polycrystalline. However, for 90 deposition cycles, the resulting Pt nanoparticles exhibit various irregular shapes such as sphere, ellipse, bar, etc. The observed decrease PD0332991 nmr in the density of Pt nanoparticles should be attributed to the coalescence between adjacent nanodots, which is incurred by a long deposition time. Based on the above discussion, 70 deposition cycles are advisable to achieve high-density Pt nanodots on the surface of Al2O3. On the other hand, it should be noticed that the substrate surface BAY 57-1293 has a great influence on the growth of metal nanodots. As an example, compared to the surface of ALD Al2O3 film, the surfaces of thermal SiO2 and H-Si-terminated silicon are not in favor of the growth of Pt and Ru nanodots and thus cannot achieve high-density nanodots [7, 16]. This is due to the fact that the surface chemistry determines the initial nucleation of metal. Figure 6 Planar TEM images of ALD Pt on Al 2 O 3 film. Corresponding

to (a) 70 cycles, together with an electron diffraction image of selected area, and (b) 90 cycles. As the deposition cycles increase continuously, the Pt particles become bigger and bigger, and the probability of coalescence between Pt particles increases gradually. As shown in Figure 7a, when the

deposition cycles increase Cytidine deaminase up to 120, a discontinuous Pt thin film is formed, i.e., the Pt film is interrupted by pinholes in some regions. Further, a perfect Pt film without any pinholes is formed when the deposition duration reaches 200 cycles, shown in Figure 7b. Figure 7 Cross-sectional TEM images of ALD Pt corresponding to different deposition cycles. (a) 120 and (b) 200 cycles. Memory characteristics of MOS capacitors with Pt nanodots Figure 8 shows the C-V C59 wnt in vitro hysteresis curves of the MOS capacitor with Pt nanodots in comparison with the counterpart without Pt nanodots. It is indicated that the capacitor with Pt nanodots exhibits a hysteresis window as much as 10.2 V in the case of +15 V to -15 V of scanning voltage. However, the hysteresis window for the capacitor without Pt nanodots is as small as 0.28 V. This reveals that the Pt nanodots have significant charge trapping capability. Figure 8 High-frequency (1 MHz) C – V hysteresis curves of the MOS capacitors. (a) Without Pt nanodots and (b) with Pt nanodots. In order to investigate the programmable and erasable characteristics of the memory capacitor, the MOS capacitor with Pt nanodots was programmed and erased, respectively, under different voltages for 1 ms, as shown in Figure 9. It is found that the resulting C-V curve shifts noticeably towards a positive bias with increasing the programming voltage from +8 to +12 V, see Figure 9a.

Comments are closed.