5 to 3.0 nm. The individual modulation layer thickness of the multilayered film was obtained by controlling the

staying time of the substrates in front of each target. The monolithic FeNi film (without insertion of V nanolayers) was also fabricated for comparison. The thickness of all films was about 2 μm. Characterization The microstructures of FeNi/V nanomultilayered films were investigated by X-ray AZD1152 diffraction (XRD) using Bruker D8 Advance (Bruker AXS, Inc., Madison, WI, USA) with Cu Ka radiation and field emission high-resolution transmission electron microscopy (HRTEM) using Philips CM200-FEG (Philips, Amsterdam, The Netherlands). The composition was characterized by an energy-dispersive spectroscopy (EDS) accessory ICG-001 mw equipped in a Philips Quanta FEG450 scanning electron microscope (SEM). The XRD measurements were performed by a Bragg-Brentano (θ/2θ) scan mode with the operating parameters of 30 kV and 20 mA. The diffraction angle www.selleckchem.com/Proteasome.html (2θ) range for

high-angle diffraction pattern was scanned from 40° to 70°. The preparation procedures of the cross-sectional specimen for TEM observation are as follows. The films with a substrate were cut into two pieces and adhered face to face, which were subsequently cut at the joint position to make a slice. The slices were thinned by mechanical polishing followed by argon ion milling. Results and discussion Figure 1 shows the typical cross-sectional HRTEM images of the FeNi/V nanomultilayered film with V layers deposited for 6 s. From the low-magnification image of Figure 1a, it can be seen that the FeNi/V nanomultilayered film presents a compact structure

and smooth surface, with the thickness of about 2.0 μm. Figure 1b exhibits that the FeNi/V nanomultilayered film is composed of a microscopic multilayered structure. It is clear from the magnified Figure 1c that FeNi and V layers form an evident multilayered not structure with distinct interfaces. The thick layers with dark contrast and thin layers with bright contrast correspond to FeNi and V, respectively. Figure 1 Cross-sectional HRTEM images of the FeNi/V nanomultilayered film with V layers deposited for 6 s. (a) Low magnification. (b) Medium magnification. (c) High magnification. The XRD patterns of the monolithic FeNi film and FeNi/V nanomultilayered films with different V layer thicknesses (t V) are shown in Figure 2. It is worth noting that, from the EDS results, the composition (at.%) of the monolithic FeNi film is 49.56% Fe and 50.44% Ni, which is basically consistent with that of the Fe50Ni50 (at.%) alloy target. The composition of the FeNi layer in the FeNi/V nanomultilayered film is consistent with that of the monolithic FeNi film because both films were prepared by the same Fe50Ni50 (at.%) alloy target. It can be seen that the monolithic FeNi film exhibits a fcc structure (γ), without existence of martensite (α) with a bcc structure.