In the first step, after the weighing of these two compounds, the resin was mixed with the MWCNTs using a high-shear T-25 ULTRA-TURRAX® (IKA, Rawang, Selangor, Malaysia) mixer for 2 min. This mixer guarantees a high and homogeneous mechanical dispersion of the carbon filler inside the resin. Material dispersion is a crucial point in order to obtain a uniform performance of the SCH727965 ic50 final product. In the second step, the hardener was added to resin/MWCNT composite and mechanically mixed at 1,200 rpm for approximately 5 min. The final composites were poured into moulds once good dispersion
was achieved. The shape and the thickness of the samples (see Figure 1, left panel) were chosen in order to fulfill the requirements of the setup of the complex permittivity measurements. The moulds filled with the composite were placed in a vacuum chamber to remove all air bubbles in the samples due to mixing. The samples were then cured in the oven at 74°C for 4 h in order to speed up the polymerization,
as prescribed by the polymer datasheet. In Figure 1 (left panel), real-scale images of 1 wt.% MWCNTs/epoxy (black specimen) and pristine epoxy (transparent specimen) are shown. Figure 1 Image of NC and sketch of the setup. Left panel: image of NC (pristine epoxy resin reinforcement) (black) and polymer (pristine epoxy resin) (transparent). Right panel: sketch of the measurement setup. As the dispersion of MWCNTs inside the resin is a crucial point, it was checked using field emission scanning electron microscopy Racecadotril BGB324 (FESEM; Zeiss Supra 40; Carl Zeiss AG, Oberkochen, Germany) by analyzing the exposed surfaces of the crio-fractured
samples. Breaking the specimen into two pieces after flash-freezing in liquid nitrogen guaranteed that the internal structure was not affected by the fracture, avoiding internal resin elongation with subsequent MWCNT reorientation. To obtain high values of the real part of permittivity, the volume fraction should be above the percolation threshold [10]. For long fibers with large aspect ratio (AR), the volume fraction value at the percolation threshold can be approximately evaluated as 1/AR [4, 9, 11]. Consequently, for the MWCNTs used in this work, we can estimate a value around 0.3 vol.%. The volume fractions φ were obtained from the weight fractions of MWCNTs using the densities of MWCNTs (ρ MWCNTs = 2.05 g cm-3), the polymer matrix (ρ poly = 1.3 g cm-3) and their weight ratio x, as reported in [12]: (1) In our investigation, 1 and 3 wt.% correspond to 0.64 and to 1.92 vol.%, respectively. In both cases, the volume fraction was above the percolation threshold. Further, considering time-harmonic fields, constitutive elements are a complex numbers and a complex permittivity which can be defined as = – jγ/ω = ′ - j ″, with γ being the conductivity and ω the angular frequency [13].